Georgia-Pacific
Manufacturing facility coatings, structural silver, equipment, and process-area systems.
- Market Sector
- Industrial
- Services Performed
- 3
Manufacturing facility coatings, structural silver, equipment, and process-area systems.
Project detail
This entry documents commercial project experience from our qualifications record. Photography, durations, and named references are published once the owner or general contractor approves release in writing. For a prequalification or bid, contact us and we will provide project references directly.
What This Engagement Covers.
Protective Coatings
CSI 09 96 00High-performance protective coatings for steel, concrete, and equipment, selected against chemical exposure, washdown, abrasion, and weather.
- Structural steel protective systems
- Chemical- and washdown-resistant wall coatings
- Tank exteriors and equipment coatings
- Secondary containment systems
Pressure Washing
SVC / PWCommercial pressure washing for buildings, concrete, and site elements, pressure and chemistry matched to the surface, not maxed out.
- Building exterior washdown ahead of coating
- Soft washing for EIFS, stucco, and siding
- Concrete, sidewalks, and drive-through lanes
- Dumpster pads and service areas
Exterior Painting
CSI 09 91 13Exterior painting over tilt-wall, stucco, EIFS, masonry, siding, and steel, bought on how long it lasts, which is decided by preparation.
- Tilt-wall and precast concrete coatings
- Stucco and EIFS repaint, including elastomeric systems
- Masonry, brick, and CMU coatings
- Siding, fascia, and trim on residential exteriors
What Goes On the Wall, and What Happens First.
Coatings are specified against the substrate and the service the surface has to take, then confirmed with the manufacturer before pricing. Nearly every finish that fails early fails in preparation, not in the can, so preparation carries its own line and its own sign-off.
- Steel
- Rust-inhibitive primer with urethane topcoat
- Chemical Exposure
- Novolac or specialty resin matched to the exposure
- Containment
- Chemical-resistant systems for the stored product
- Washdown
- Catalyzed systems rated for the cleaning regime
How This Job Was Run.
- 02
Scope Review
Scope gaps cause more disputes than any finish issue. We walk the scope line with the general contractor before award, which surfaces, which side of the demising wall, whose doors, whose ceilings, and put the answer in the contract instead of discovering it during construction.
- 04
Surface Preparation
Cleaning, profiling, moisture and adhesion testing where warranted, substrate repair, and priming to the manufacturer specification. Preparation is priced as its own line item so it is visible, and so a budget reduction is a decision not something that quietly happens.
- 06
Quality Control
We run our own quality-control inspection ahead of the general contractor's walkthrough. Coverage, sheen uniformity, cut lines, and adjacent-surface condition are checked and corrected before anyone else is asked to look at the work.
- 08
Project Closeout
Attic stock, the approved color schedule, product data, and the one-year workmanship warranty are delivered as a package at turnover. Warranty support continues after closeout. A call after closeout gets the same response as a call during construction.
Service Environment Drives the System
Chemical exposure, washdown, thermal cycling, and abrasion each rule out different products. The system is selected against the actual service conditions and confirmed with the manufacturer before it is priced.
Shutdown Windows
Work that requires a line to stop is planned to the hour. Scope is broken into what can be done live, what needs the line down, and what needs the area fully cleared, priced separately so the plant can decide.
More Industrial Projects.
Bidding Similar Work?
Send the plans and the specification sections. We confirm receipt, tell you whether we are bidding, and state our assumptions and exclusions in writing. Call 972-863-1919.